944 Turbo Performance Kit A (24 Pin)

9Republik performance kit A for the 944 Turbo.

Suitable for

• 1985 to 1992 944 turbo models (220 and 250)

Kit Includes

• 9Republik replacement chip for 944 main engine management computer (DME)
• 9Republik replacement chip for 944 anti detonation engine management computer (KLR)
• 9Republik 3.0 Bar fuel pressure regulator
• 9Republik Boost improver for standard 944 turbo wastegates
• Full installation instructions

Standard Performance output

• 1986 to 1988 944 Turbo with K26/6 (220) turbo - 220 BHP - 250ft lbs torque
• 1988 to 1992 944 Turbo with K26/8 (250) turbo - 250 BHP - 250 ft lbs torque

9 Republik Kit A Performance output

• 1986 to 1988 944 Turbo with K26/6 (220) turbo - 285 BHP - 320 ft lbs torque
• 1988 to 1992 944 Turbo with K26/8 (250) turbo - 298 BHP - 320 ft lbs torque

Features.

• Our very evolution of maps and software pre loaded onto the chips which are ethanol friendly (most other chips out there stopped development before ethanol started creeping into our fuel and can cause detonation.)
• Evolved on the basis of over 35 years constant improvement, and the chips that used to consistently break the UK 944 Turbo dyno league records.
• Includes everything you need to transform your Porsche 944 Turbo's performance.
• Probably the single best value for money improvement you will ever make to your 944 turbo.
• Dyno Charts available on request.

Installation difficulty.

• Following the instructions the kit should be installed within a couple of hours at most by a DIY mechanic.
• Setting up the boost afterwards can be completed in about half an hours driving, ideally with a friend in the passenger seat to jump out of the car periodically to adjust the boost improver and to watch the boost gauge on the dashboard (Only reads upto 14.4 psi above atmostpheric)
• We ideally recommend you buy one of our boost gauges that replaces the small standard storage slot under the radio, which houses a round boost gauge and a smaller storage slot next to it as this will allow you to set the full 18 psi of boost and be able to monitor it on an ongoing basis.